Wood plastic, also known as plastic wood, is abbreviated as WPC in English. It can replace solid wood and anticorrosive wood, and has the advantages of maintenance-free, aging-resistant, wear-resistant, corrosion-resistant, non-cracking, insect-resistant, mildew-proof and moisture-proof. Therefore, more and more wood plastic guardrails (fences, railings) are used in landscape gardens, courtyard gardens, etc.
Installation preparation:
Electric drill: The electric drill is a tool that must be used during the installation process: because the density of wood plastic material is relatively high (about 1.3g/cm³), the material is hard and brittle. Therefore, when fixing the guardrail of wood plastic material, you must first use an electric drill to make holes, and then screw in the screws to fix it, instead of nailing directly, otherwise the material may be broken or cracked.
Other tools: During the installation process, ordinary woodworking tools are also needed.
Stainless steel screws: During installation, we recommend using matching wood plastic guardrail fasteners (engineering plastic injection molding parts) and stainless steel screws for fixing. The amount used is determined by the actual situation, and the main determining factor is the design of the guardrail. During the paving process, it is necessary to make holes first and then fix the screws.
Wood-plastic materials: columns, square tubes, handrails, injection-molded connectors, professional fixing kits, stainless steel screws, etc.
Safety tips: Please use labor protection gloves during construction.
Installation steps
1: Fix the plastic wood column
Fix the special fixings of the plastic wood column to the concrete floor with expansion screws (the length of the expansion screws is determined by the thickness and quality of the concrete floor at the construction site). First, put the column into the professional fixings of the column. Generally, the distance between the columns is about 1.5 meters. The specific distance is determined by the actual local situation or design plan, including the flow of people and the surrounding environment of the installation site (as shown below).
2: Prepare the handrail and square tube of the specified length first, and use the square tube connector to connect them. First, fix the square tube connector at the corresponding position of the handrail, then put the prepared square tube into the connector, and finally install another handrail. The distance between the square tubes depends on the specific situation. The reference distance is 100-200mm. The distance between the handrails depends on the specific situation. It is recommended to be 800-1000mm (as shown below).
3: Install the installed handrail and the column through the handrail connector. During installation, the handrail and the column cannot be tightly connected. A 3-5mm expansion joint should be reserved on each side. The installation height depends on the specific situation (as shown below).
4: Fix the cap to the column. The cap can be made of wood-plastic material or injection-molded cap, which is selected by the customer (as shown below
Notes on installation of plastic wood guardrail: The water absorption rate of wood-plastic material is about 0.2%, and the expansion rate is about 0.5%. Therefore, when installing this guardrail, a certain expansion joint should be reserved between the wood-plastic profiles according to the actual situation to accommodate the thermal expansion and contraction of the material.






